OpenDecoder

Content → Command Stations → BiDiB

• Configuration | Setup examples | USB Mapping | OpenDecoder

• 3 or 4 aspects with distant signal and blank at HP0/Sh1

1. Interface
   • Protocol: NMRA-DCC
   • Address Main Signal: 1, 5, 9 or 13 and so on. (Flat addressing: 8 addresses per decoder)
   • Port: 0, Flat addressing
   • Control: Linear
   • Type: Accessory
   • Option: As switch
2. Details
   • Aspects: 3 or 4
   • Signal Type: Lights
   • Signification: Main
   • Aspect number: green=2, red=1, yellow=0, white=3

The aspect numbers will map the output/aspect of the decoder; Change according your needs.

• In case the signal symbol shows "red" and the signal LED is showing "green", just swap 2 and 1. Keep the aspect numbers in the range of 0 - 3; Higher values will address the next decoder.

Use the same settings as for the main signal except for:

1. Interface
   • Address: 3, 7, 11, or 15 and so on.
2. Details
   • Aspects: 3 or 2
   • Signification: Distant