Configuration of TAMS Decoders

Content → Command Stations → Tams MasterControl & RedBox

• WD-1

The TAMS Weichendecoder WD1 can control 4 switches without separate switch controller (in the same manner as Maerklin's K83).

The WD1 uses only one address of the Central Station. This is the same address you have configured in the jumper settings.

Menu → Tables → Turnouts → General

• ID = <any name of the Turnout>
  
  

Menu → Tables → Turnouts → Interface

• Protocol = Motorola
  
• Address = <Jumper address of the WD1> - If the jumper is set to "1", you must use the address "1"!!
  
• Port = <Portof the WD1> Port can be a value between 1 - 4 ;)