Bit | Address | Mask |
---|---|---|
1 | 0 | 0x01 |
2 | 1 | 0x02 |
3 | 2 | 0x04 |
4 | 3 | 0x08 |
- | 4 | not used |
- | 5 | not used |
Go to position 5: activate address 0 and address 2.
Starts the turntable bridge to turn to the new position.
This flag sets all bits to zero. If the turntable turns and the reset is activated, the turntable will stop on the first following position.
The reset flag is always given before a new address is loaded.
The "motor off delay" time, defined in the "interface" setup, is used as pause between the commands.
Normaly a value of 150 (milliseconds) will satisfy.