User Tools

Site Tools


autocommands-en

Auto Commands

ContentAutomatic Mode

  • Commands


Auto mode ON

This command will enable the auto mode and set all signals, linked to a block, to red.

Start all locs

All locos in the list will receive a go command.

Stop all locs

All running locos in auto mode will be send a stop request. The actual stop depends on which state the auto mode is for a certain loco. A defined stop is after the in event in a block.

Resume all locs

This command will start all trains which were running in auto mode before the last Stop all command was issued.
In the Rocview loco pane the mode is prefixed with an asterisk if the resume flag is set.

Emergency Stop

The keyboard key Pause can be used as Emergency Stop.
An alternative solution is using a Sensor input setup with a System.Stop action.

autocommands-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1