CAN-digital-Bahn

Content → Command Stations → CAN-digital-Bahn

This version uses the Märklin CS2 protocol:

• cs2can-protokoll-2_0.pdf

Set it up as a Märklin CS2 CS with type serial.

Fixed Serial Line Settings: 500000, 8N1, CTS
Fixed packet length: 13 Bytes.

Flow control with CTS is fixed and independent of this setting.

The version should be set to 2 to disable S88 polling continually.

The sensor range to be queried at “Start of Day”.

This is for special CS2 compatible Command Stations which can not handle high data traffic.
This sleep value will also be used for waiting on the next byte. (In some cases needed under Mac OSX: 17…20ms)

See for special support: Sensor events

• http://www.can-digital-bahn.com

Setup as Lenz XpressNet CS.

• LI101F
• 19200, CTS
• V2