Differences

This shows you the differences between two versions of the page.

--- dcc232-en [2019/07/05 01:57] – [Links] rainerk
+++ dcc232-en [2020/08/23 00:52] (current) – [Short circuit checking] rainerk
@@ Line 20: / Line 20: @@
   * no command station needed (third party firmware)
   * complete control of the process
-  * only modem privilege is needed for accessing the serial device¹
+  * only modem privilege is needed for accessing the serial device
   * runs under Windows and Linux
  \\
-¹) No [[:ddx-en#known_limitations|special device driver]](Windows), or super user privilege(Linux), is needed for accessing the serial port. This in contrary to **[[:ddx-en|DDX]]**.\\
- \\
 =====Disadvantages=====
-  * The generated DCC signal does not fully conform to the NMRA standards; Some decoders will not operate or only partial, see **[[:ddx-en#black_whitelist|Black/White List]]**.
+  * The generated DCC signal does not fully conform to the NMRA standards; Some decoders will not operate or only partial.
-  * No direct support for occupancy detection; A separate interface, like the [[:mgv85-en|GCA85]]/[[:mgv101-en|GCA101]], is needed for getting events. \\ This is not really a disadvantage because best practices dictate that a separate system for occupancy detection and stationary decoders be used.
+  * No direct support for occupancy detection; A separate interface, like the [[:gca85-en|GCA85]]/[[:mgv101-en|GCA101]], is needed for getting events. \\ This is not really a disadvantage because best practices dictate that a separate system for occupancy detection and stationary decoders be used.
   * No service mode programming. (PT)
  \\
@@ Line 70: / Line 69: @@
 ===== Setup =====
-{{ :dcc232:dcc232-ord3.jpg?400}}
+{{ :dcc232:dcc232-ord3.jpg?350}}
 Only the IID and the serial port has to be set, the rest is optional.\\
-{{:dcc232:dcc232-setupdlg-en.png}}\\
+{{:dcc232:dcc232-setupdlg-en.png?600}}\\
  \\
@@ Line 107: / Line 106: @@
 The time in milliseconds the short circuit must resist before the Rocrail server is informed of a short circuit.\\
+==== PT ====
- \\
+=== fastcvget ===
+Usable in cases of an old native RS232 interface, to get a fast reading of the CV's.\\
+  * **Note:** With very many of USB-RS232 converters, the reading CV's is __not possible__, because the RI connection of the RS232 (pin 9) is not supported.\\
+\\
 ====== Links ======
   * http://www.youtube.com/watch?v=6YVlRja9VDY
   * https://www.nmra.org/sites/default/files/s-92-2004-07.pdf