Dinasys Turntable Controller

Introduction

This CS can only be used with a Dinasys Turntable Controller.
The Rocrail definition must be set to protocol Multiport and Interface-ID pointing to this controller.

Setup

All parameters are ignored except for IID, Port and Version.

Port

The serial device name connected to the DTC.

Options

Version Turntable Type
0 Default
1 DTC 48 tracks
2 DTC 24 tracks
3 DTZ 24 tracks 15°


Position sensor

If the end position has been reached it will be reported by sensor address 10001.
See: Position sensor


Protocol


Personal Tools