gca-pi04-en
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
gca-pi04-en [2018/11/12 08:56] – external edit 127.0.0.1 | gca-pi04-en [2020/12/30 14:17] (current) – [GCA-PI04 RocMouse.] rjversluis | ||
---|---|---|---|
Line 2: | Line 2: | ||
[[english|{{ | [[english|{{ | ||
[[english|Content]] -> [[hardware-en|Hardware]] -> [[hardware-en# | [[english|Content]] -> [[hardware-en|Hardware]] -> [[hardware-en# | ||
- | * [[GCA1-PI01-en|GCA-PI01]] | [[GCA_PI02-en|GCA-PI02]] | [[gca-pi03-en|GCA-PI03]] | **[[gca-pi04-en|GCA-PI04]]** | [[: | + | * [[GCA1-PI01-en|GCA-PI01]] | [[: |
* [[mgv-overview-en|The GCA modules]] | * [[mgv-overview-en|The GCA modules]] | ||
* [[: | * [[: | ||
+ | \\ | ||
+ | | Discontinued, | ||
\\ | \\ | ||
{{: | {{: | ||
- | + | \\ | |
===== Description ===== | ===== Description ===== | ||
Line 16: | Line 17: | ||
Assigning a loco to a throttle is done with the dispatch command.\\ | Assigning a loco to a throttle is done with the dispatch command.\\ | ||
There is furthermore not much to explain about this unit.\\ | There is furthermore not much to explain about this unit.\\ | ||
- | No microprocessor is needed, since all inteligence | + | No microprocessor is needed, since all intelligence |
Just one 8 bit I2C expander and 1 A/D I2C converter is used.\\ | Just one 8 bit I2C expander and 1 A/D I2C converter is used.\\ | ||
Like GCA-PI02 and GCA-PI03, this unit also contains a line driver, to enable longer wiring.\\ | Like GCA-PI02 and GCA-PI03, this unit also contains a line driver, to enable longer wiring.\\ | ||
- | The used potentiometer | + | The used potentiometer is a cheap standard type pot with 6 mm axle.\\ |
It will be suitable for all circumstances.\\ | It will be suitable for all circumstances.\\ | ||
There is however room on board to replace it with the much more expensive sealed types.\\ | There is however room on board to replace it with the much more expensive sealed types.\\ | ||
- | To achieve a more stable reading from the speed selector, an extra 3,3V stabilzer | + | To achieve a more stable reading from the speed selector, an extra 3,3V stabilizer |
- | Also, to avoid reaction on the speed while pushing S6 or the reverse switch, these switches have addional | + | Also, to avoid reaction on the speed while pushing S6 or the reverse switch, these switches have additional |
This all together results in a very nice hand held throttle, and very easy to assemble yourself.\\ | This all together results in a very nice hand held throttle, and very easy to assemble yourself.\\ | ||
gca-pi04-en.1542009364.txt.gz · Last modified: 2018/11/12 08:56 by 127.0.0.1