User Tools

Site Tools


locoio-opc-en

LocoIO OPC

ContentRocviewProgrammingStationary Decoders


Introduction

OPC = Operation Code

Inputs can generate, beside the specific message, an extra LocoNet message which can be defined with this LocoIO dialog tab.
Only 4 byte messages are supported, whereby the last byte(checksum) automatically is added before sending it.


Setup



Port

The LocoIO port to program. Range 1-16.

OPC

The extra OPC must be one of the 4 byte range as documented in the LocoNet-PE.

Argument 1 / 2

Check the 4 byte message documentation, or the LocoNet-PE, for details.


Example

Control an extra switch with a different address and one LocoIO input can be configured like this:

OPC Arg1 Arg2
OPC_SW_REQ = 0xB0 = 176 67 48

Port 68, contact 2.
On how the arguments are calculated is documented in the LocoNet PE.

locoio-opc-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1