mgv-programming-en
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | mgv-programming-en [2018/11/12 08:56] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== GCA136 Servo ====== | ||
+ | [[: | ||
+ | |||
+ | [[: | ||
+ | * [[: | ||
+ | // \\ // \\ | ||
+ | |||
+ | ===== Introduction ===== | ||
+ | The programming is established with plain switch commands without any feedback from the servo-controller.\\ | ||
+ | Previous settings of GCA decoders are saved in the rocview.ini for later use.\\ | ||
+ | To activate this setup menu, select Programming > GCA > GCA136\\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | ===== Setup ===== | ||
+ | {{mgv-programming-en.png}}\\ | ||
+ | :!: Make sure the **C2** option ist set in the **[[mgv136-en# | ||
+ | |||
+ | **Remarks on programming GCA136 with RocNet:** \\ | ||
+ | Due to a serious difference in timing with Raspbery Pi running RocNet, \\ | ||
+ | it might happen that programming will not start the first time after initiation.\\ | ||
+ | In that case, just restart programming.\\ | ||
+ | \\ | ||
+ | ^ Even if not all servo connections are used, it is necessary to have all 4 addresses / ports set, \\ because the programming commands are transmitted in parallel as a series of coded 4-bit values. ^ | ||
+ | |||
+ | ==== Interface ID ==== | ||
+ | Only needed if the decoder is not connected to the default interface.\\ | ||
+ | | //The programming is done with normal switch commands so the GCA136 could be connected to a none GCA accessory decoder.\\ The **[[: | ||
+ | |||
+ | ====Bus==== | ||
+ | See: **[[: | ||
+ | |||
+ | |||
+ | ==== Address/ | ||
+ | Normal Rocrail addressing.\\ | ||
+ | The four addresses must be followup pins on one decoder like the GCA50.\\ | ||
+ | With LocoIO (GCA50) will setup here Address = “0” and Port = “Address of LocoIO port”. | ||
+ | |||
+ | |||
+ | ==== Single gate ==== | ||
+ | Use this option **ONLY** if the GCA136 is connected to the **[[: | ||
+ | |||
+ | ==== ON ==== | ||
+ | Set all outputs to the default position and activate programming mode.\\ | ||
+ | |||
+ | ==== OFF ==== | ||
+ | Deactivate programming mode.\\ | ||
+ | |||
+ | |||
+ | \\ | ||
+ | ===== Servo ===== | ||
+ | {{mgv-servo-en.png}}\\ | ||
+ | For GCA136 and compatible servo controllers.\\ | ||
+ | Programming commands are send directly after releasing the thumb of the sliders or by selecting the relay or servo selection.\\ | ||
+ | |||
+ | ==== Left/Right angle ==== | ||
+ | Adjustable right and left rotation angle to meet the environment of the servo.\\ | ||
+ | ==== Speed ==== | ||
+ | Servo speed selection.\\ | ||
+ | ==== Polarization Relay ==== | ||
+ | Position of the polarization relay, | ||
mgv-programming-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1