MGV102

Reverse loop circuit

Content → Hardware → MGV

• The MGV Family

Many railroaders have problems with reverse loops.

This unit gives an ultimate solution in digital systems.

It is not suiteable for analogue systems.

It is provided with several feed-back outputs to connect a LocoIo module MGV50, for full compatibility with Rocrail.

Also in manual digital control, this unit will provide the correct switching for your reverse loop.

4 current detectors are on board to enable correct swap of rail power lines.

1 extra current detector is on board to get a rail occupied indication inside the loop.

Opto couplers are on board to separate rail power from Loconet.

Auto reset multifuses are on board to protect current sensors from overlaod in short circuit situation.

The standard 10 pin header connector is compatible with the 10-pin connector on MGV50 (LocoIO).