Interface

Content → Objects → Outputs

• General | Interface

Output Dialog Interface Tab.

If you have more than one Command Station you can use this field to link this output with the CS you actually wired it with. Leave blank in case you have only one CS or when it is wired to the default CS. (First digint in the rocrail.ini)

See: Addressing

It is system dependent if this parameter should be set, and is only from interest for SRCP, DDX, Dinamo and OpenDCC.

The addressing of accessories are described in chapter Addressing

Some systems support an extra parameter for outputs:

• Dinamo (OM32 type, level=1…15)
• BiDiB with blink option activated (Type=Lights, range 1…9)
  1. BIDIB_PORT_TURN_ON
  2. BIDIB_PORT_DIMM_OFF
  3. BIDIB_PORT_DIMM_ON
  4. BIDIB_PORT_TURN_ON_NEON
  5. BIDIB_PORT_BLINK_A
  6. BIDIB_PORT_BLINK_B
  7. BIDIB_PORT_FLASH_A
  8. BIDIB_PORT_FLASH_B
  9. BIDIB_PORT_DOUBLE_FLASH

Switch commands are send instead of output commands when this option is set.

This option is only usable in combination with the switch option to swap the on/off command.

Send a blink command at ON.

• Dinamo OM32
• BiDiB port type “Lights”

Some systems, like BiDiB, make difference between accessory and other command types.
For all other systems this flag has no effect.

Port type selection.
Some decoders, like BiDiB LightControl, provide different port types on the same local address.