N-Terminal Demo


mergCBUS

n-terminal-demo-cbus.jpg

From left to right:
CAN-GC3, GCA93, CAN-GC2, GCA93, CAN-GC6/GCA137, CAN-GC4, ID-20, CAN-GC1e.


mergCBUS

ndemo-can.jpg

Replaced LocoNet, OpendDCC and BiDiB with CAN-GC*.
From left to right:
CANCMD, MGV93, CAN-GC2, MGV93, MGV136/137, CAN-GC2, CAN-GC1.
The CANCMD will be replaced as soon as the CAN-GC3 comes available.


Setup Rocrail

First impression of how the plan looks like in Rocview.


Setup servos

servo-sensor-setup.jpg

Servo setup was easy and is successfull; Tnx to the very good MGV136.
I only forgot to reset the MGV50 after changing inputs to output, which did me wonder why it did not want to program the MGV136… Be warned! ;)
Also the BiDi-GBM is tested and works as expected.


The idea

testlayout-mm.jpg

  • Date: 01-04-2011
  • Dimensions: 140 x 16 x 5,5 cm

The idea is to create a small N-Terminal Station Demo based on testlayout-en.

Materials

  • Peco Code 55 rails
  • Relay Servo switch motors
  • The servos will be controlled by the MGV136/137 and the RailCom/Current sens by the OpenDCC BiDiGBM.

Logic

  • 7 blocks
  • 8 routes
  • 4 signals
  • 2 block sensors


Gallery

n-terminal-01.jpg n-terminal-02.jpg n-terminal-03.jpg n-terminal-04.jpg
n-terminal-05.jpg n-terminal-06.jpg n-terminal-07.jpg n-terminal-08.jpg
n-terminal-09.jpg n-terminal-10.jpg


Servos

Not having aluminum profile or an other mount construction I used double-sided adhesive tape: I wonder how long it will last. ;)
(The tape is normally used for mirrors in humid bathrooms.)
double-sided-adhesive-tape.jpg


Electronics

Part I

The LocoBuffer capacitor is a little too high and must be dismounted from the PCB. Horizontal, besides the PCB, will be the solution. A lot of wiring is done, but the delivery of the missing servos is pending…
n-terminal-11.jpg n-terminal-12.jpg

Part II

n-terminal-13.jpg



Personal Tools