Menu

Content → Rocview → General

• Menu | Configuration | Software Updates | Locomotives Tab | Accelerators | Command Station Status | Use multiple Gui's for viewing | Reports

If the Rocview is not connected to a server or it should be connected to a different one it can be setup with this dialog.

Disconnect from the Rocrail server to be able to edit locally offline.

Modify Rocview settings explained in chapter Configuration.

Most settings are explained in chapter Rocrail configuration.

Note: This option is only available if Rocview is currently connected to a Rocrail server.

Changes the track plan title for the current layout.

Opens a Rocrail Workspace

To create or open a track plan, respectively.
See: Create / modify a Track plan

Note: These options are only available if Rocview runs offline, i.e. is not connected to a Rocrail server.

Saves the current track plan.

Tip: The track plan is automatically saved if Rocview and Rocrail are quit.

Saves the current track plan under a different name.

Note: If the plan is saved under name different from the current one the path to the file has to be adjusted manually in the rocrail.ini or from the Rocrail properties menu and the server has to be restarted.

Analyses the current track plan.

Note: This option should be used by advanced users only!

The Rocrail server saves the received file with the name specified in the plan file in its local work directory.
The new plan will be used after it is changed in the General Tab and the server is restarted.

Note: This option is only available if Rocview is currently connected to a Rocrail server.

Exits Rocview and subsequently the Rocrail server.

Note: This option is only available if Rocview is currently connected to a Rocrail server and the server does not run in Console Mode or runs in a previously opened Workspace.

Disconnect from server, if connected, and exit Rocview.

The Undo Dialog is only available if there are deleted objects in edit mode.

Flips Auto mode on/off.

Start all locomotives available in the table.
In auto mode available.

Start all locomotives stopped in a previous session.
In auto mode available.

Signal all running trains to stop in the current or next block.
In auto mode available.

All active objects will get a (soft) reset signal, and current block reservations will be preserved.
In auto mode available.

All active objects will get a (hard) reset signal; block reservations will be reset too!
In auto mode available.

Sub menu for edit the layout in edit mode.

All object tables are listed and accessable in this sub menu.

To make sure all switches and signals have the right position this command flips them all twice.
All defined signals will be sent a command with the last known state, or 'RED' If no state is available.
See also: Command Line Options and Console Mode

At init field the following counters are reset:

• wheel counter
• sens counter

Request the status of all sensors.
Supported Command Stations:

• CBUS
• LocoNet
• Xpressnet
• BiDiB

Some Command Stations accept Short ID for use with throttles.

Special stationary and mobile programming dialogs.

Sub menu for translations and representation options.

Only one of both can be set hidden for Multiple Rocview instances purpose.