route-manual-en
Differences
This shows you the differences between two versions of the page.
— | route-manual-en [2018/11/12 08:56] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Manual Routes ====== | ||
+ | [[english|Content]] -> [[english# | ||
+ | * **Manual operated routes** | ||
+ | * [[route-manual-en-blueprint|Blueprint]] | ||
+ | ===== Setup ===== | ||
+ | * CTC Route wiring: [[route-wiring-en| route wiring]] | ||
+ | * set route to manual: [[route-gen-en| route general ]] | ||
+ | * set one or more locos to use manual routes: | ||
+ | |||
+ | \\ | ||
+ | |||
+ | ===== CTC Wiring ===== | ||
+ | [[route-wiring-en|CTC support]] introduced a route locking itself with its route ID.\\ | ||
+ | This new phenomena can be used for manual routes: | ||
+ | * Loco property: use only routes which are locked by itself. | ||
+ | * Manual routes will accept locking if locked by itself. | ||
+ | * The Loco frees up the route after reaching the next block. | ||
+ | |||
+ | \\ | ||
+ | CTC can also be used with virtual buttons instead of real hardware.\\ | ||
+ | Use the sensor symbols as button and map them to the virtual CS. The same addresses must be used in the route CTC setup.\\ | ||
+ | However the sensor button solution needs some extra fine tuning to behave like a button.\\ | ||
+ | As alternative to sensors the output object could be extended to behave like a button but sends the same command as a sensor to trigger a sensor emulation.\\ | ||
+ | |||
+ | |||
+ | ===== manual routes at auto mode ===== | ||
+ | |||
+ | Idea : go with manually controlled locomotives in auto mode without creating a Ghost in the block . | ||
+ | \\ | ||
+ | |||
+ | \\ | ||
+ | Create one Action setup: Type = Block; Command = schedule_manual | ||
+ | \\ | ||
+ | Create one Action setup: Type = Output; command off, timer = 5000 | ||
+ | \\ | ||
+ | \\ | ||
+ | {{: | ||
+ | 1 output Start / Finish \\ | ||
+ | 1 Action: Reset Output \\ | ||
+ | 1 schedule \\ | ||
+ | 1 action block: manual schedule \\ | ||
+ | \\ | ||
+ | | ||
+ | | ||
+ | Enter manual action schedule in output \\ | ||
+ | | ||
+ | \\ | ||
+ | | ||
+ | A new symbol is used for the two outputs. Symbol no. 5 | ||
+ | \\ | ||
+ | \\ | ||
+ | if you need more information, | ||
+ | {{: | ||
+ | |||
+ | \\ |