Destinations

Content → Objects → Schedules

• Index | Destinations | Follow-up | Locations and Schedules | Schedules Test Case 1 | Examples

ScheduleDialog Destinations Tab.

need new screen shot

This text is used as reference to this schedule and should be unique within the list of schedules.

The time entries in the schedule must match exactly with the current model-time.

The schedule times are relative to the activation of the schedule. (in model-time).

The specified From/To Hours are used for running this schedule. Hours are disregarded in the schedule entries.

The time tolerance in model minutes for allowing trains to leave by schedule in case of delay.

The cycle range in model hours for hourly schedules.

How often the schedule will be repeated entirely.

Locations explained.

If no location is specified the block ID will be used for finding a route.
Block permissions do not affect schedules.
FiddleYards are also listed if one or more are defined in the track plan.

The departure time is regarded by trains which has set this option.

The enter event and after found the next destination of a schedule entry can trigger some actions as explaned in chapter Actions.

Swap the locomotive placing flag before going to the next schedule destination after reaching this destination.
Use with care and read the Directions in Rocrail first.

Block or location must be free before starting the schedule is enabled.
At least one block must be free in case of a location.
This is only checked if the train starts at the beginning of a schedule, and with disabled option “Check for free destinations until reaching in”.

Delay for the in event in mS.
This option can be useful for shunting or for trains which should roll a little further for this schedule entry block.
This will overwrite the block event timer for enter2in.