Interface

ContentObjectsFiddle Yard



Fiddle Yard Dialog Interface Tab.

Default setup using switch commands.

Interface ID

If the decoder and sensor are connected to another command station as the default it should be linked with the correct IID as setup at the server.

Bus

See: Addressing


UID-Name

Alternative to the Bus number supported by:

  • BiDiB (String: Username)
  • RocNet


Position register

Position range is 0-127.

Address Position nible
0 0
1 1
2 2
3 3
4 4
5 5
6 6

Leave address 4..5 zero if the FY has a range of 0…15.

Invert

Invert the commands: Zero is on.

Single Gate

If the system has a flat addressing scheme like CBUS.

Accessory

The switch commands will set the accessory flag which is for some command station, like DCC++, important to determine DCC or I/O.

New position flag

This output is used to signal the FY controller that the new position is set.
By default to signal '1' the thrown command is send. Use the Invert option to swap this.

Position Sensor

Sensor which signals the end of move.
This event should also be send if the Fiddle Yard was already in the wanted position!

b0-b6 Sensor

The position byte is set by the Fiddle Yard.
No new command will be send if the wanted position equals the reported position and the position sensor is also high.
Leave b4…b6 empty if the FY uses a range of 0…15.

Type

Fiddle Yard decoder type.

Type Description Command type
D Command Station default switch
M Motorola switch
N NMRA DCC switch



Personal Tools