switch-ctrldlg-en
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | switch-ctrldlg-en [2018/11/12 08:56] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ======Switch Control====== | ||
+ | {{ : | ||
+ | [[: | ||
+ | * **Switch Control** | ||
+ | // \\ // \\ | ||
+ | |||
+ | To test switches without having them available on the layout.\\ | ||
+ | Or to find out at which address a switch is activated.\\ | ||
+ | |||
+ | {{switch-ctrldlg-en.png}}\\ | ||
+ | |||
+ | \\ | ||
+ | =====Protocol===== | ||
+ | This is Command Station dependent.; Check the manual for details. \\ | ||
+ | |||
+ | |||
+ | \\ | ||
+ | =====Type===== | ||
+ | Port type selection.\\ | ||
+ | Some decoders, like BiDiB LightControl and **[[: | ||
+ | |||
+ | \\ | ||
+ | ===== IID ===== | ||
+ | If the switch commands should go to another command station as the default this field can be used to set the destination.\\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====Bus===== | ||
+ | See: **[[: | ||
+ | |||
+ | \\ | ||
+ | ===== Decoder ===== | ||
+ | The decoder number. NMRA decoders have 4 port pairs, and the **[[addressing-en|addressing]]** is conform NMRA.\\ | ||
+ | The tooltips of the port buttons will display the FADA and PADA address.\\ | ||
+ | \\ | ||
switch-ctrldlg-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1