User Tools

Site Tools


turntable_locdec_fr

LocDec

Table des matièresObjetsPont tournant





Le moteur est controllé par un décodeur de locomotive conçu pour les types courant continu. Les fonctions sorties, lumières avant et arrière sont utilisées pour activer le pont tournant. (cables jaunes)

Configuration

The center contacts of all turntable rail-clips should be electricaly isolated, or as I did removed, and connected to s88 compatible feedback module. (Those modules accepting also the "red-wire" as input signal.) They should be declared in the plan.xml as the posfb's int the turntable tracks.

  <tt id="TT01" addr="80" x="18" y="11" z="1" type="locdec" desc="Bahnbetriebswerk Neustadt">
    <track posfb="FB300" nr="12" locfb="FB49" blockid="BL18" desc="Main entrance"/>
    <track posfb="FB305" nr="42" locfb="FB310" desc="Abstellspur"/>
    <track posfb="FB304" nr="41" locfb="FB309" desc="Schuppentor 1"/>
    <track posfb="FB303" nr="40" locfb="FB308" desc="Schuppentor 2"/>
    <track posfb="FB302" nr="39" locfb="FB307" desc="Schuppentor 3"/>
    <track posfb="FB301" nr="36" locfb="FB306" desc="Sand Wasser Kohlen"/>
  </tt>

Those feedbacks are activated by the lips of the turntable bridge center contact rail.

The turntable has 48 steps of 7.5°. The connected tracks are numbered counter-clockwise and track 0 is the 0° of the first quadrant. This is the way the RocGui renders the turntable, and this item can not be rotated.

Decoder wiring

tt-decoder-small.jpg
Decoder wirering (click to get the big picture of 300Kb)

Sensors AC

tt-feedback-getter.jpg
Position-feedback getter contact.


tt-feedback-getter-wirering.jpg
Position-feedback getter contact wirering.


tt-feedback-activator.jpg
Position-feedback activator: remove this from one side of the bridge.

Sensors DC

tt-pos-reed.jpg
For DC turntables the position sensors can be made with Reed relais and at one side of the bridge a magnet.

turntable_locdec_fr.txt · Last modified: 2023/03/18 13:59 by phil45