By Peter Giling |
---|
A straight forward connection between the RS232 and the EDiTS / Märklin booster.
* Now the good old EDITS Booster is to be rehabilitated with Rocrail DDX.
This board is a D.I.Y. project. No boards available.
Schematic design |
PCBoard + parts placement |
The bill of materials |
N.B. Self made pc-boards are not supported! |
---|
In schematics there are two connectors.
J1 is RS232 connector to PC.
J2 is connector to Edits booster
Because connector type is different, the following table gives conversion.
GCA98 J2 | Edits Booster K1 | Function |
---|---|---|
Pin 1 | Pin 3 | + 20 Volt |
Pin 2 | Pin 4 | signal |
Pin 3 | Pin 2 | ground |
Pin 4 | Pin 5 | Short circ. |
Pin 5 | Pin 1 | -20 Volt |