3d:3d-projects-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
3d:3d-projects-en [2021/05/27 19:27] – [Tips] phg | 3d:3d-projects-en [2023/08/05 14:51] (current) – removed rjversluis | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== 3D Projects ====== | ||
- | [[: | ||
- | |||
- | \\ | ||
- | =====G-Scale===== | ||
- | * [[: | ||
- | * [[: | ||
- | * [[: | ||
- | * [[: | ||
- | |||
- | \\ | ||
- | =====Tips===== | ||
- | * [[: | ||
- | \\ | ||
- | ===== printer material ===== | ||
- | A nice but not cheap material is PLApro.\\ | ||
- | Produced in The Netherlands.\\ | ||
- | No smell at all, and strong result\\ | ||
- | It needs (by experience) these setiings for as roof part of th eaggon.\\ | ||
- | ^ important settings in Cura for PLApro ^ | ||
- | | Wall line width | 0.4 | mm | | ||
- | | Initial layer line width | 0.4 | mm | | ||
- | | Infill | ||
- | | printing temperature | ||
- | | Build temperature | ||
- | | cooling fan speed | 50 | % | | ||
- | | build plate adhasion | ||
- | | brim width | 8 | | | ||
3d/3d-projects-en.1622136428.txt.gz · Last modified: 2021/05/27 19:27 by phg