6050-en
This is an old revision of the document!
Table of Contents
Marklin 6050/6051
Content → Command Stations → Marklin 6050/6051
Deprecated and no longer supported! |
Because of the lack of a direction bit in this ancient protocol some features will probably not work in auto mode.
Cable configuration
Interface 6050/6051 to RS232
DIN-6 | D-SUB-9 | Label |
1 | 3 | Rx |
4 | 2 | Tx |
5 | 8 | CTS |
3 | 5 | Ground |
Bridge on D-SUB-9 side pin: 4 - 6 - 1
Settings
Line settings
Baudrate
2400
Hardware Flow
CTS
Sensors
Number
Number of s88 units.
Version
If the version is set > 0 an extra sleep of 10ms is added after the CTS came active.
With version 2, the direction change will skip the preceding speed zero command. (14.357+)
Switch time
Time in ms to wait after the last switch command before a switch off command is send to prevent coil damaged.
Interface 6023
The 6023 interface must be switched to binary mode for using this protocol; Read section 6 on how to switch to binary mode.
6050-en.1542009373.txt.gz · Last modified: 2018/11/12 08:56 by 127.0.0.1