arduino:wio-setup-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
arduino:wio-setup-en [2020/04/28 15:09] – [DCC] rjversluis | arduino:wio-setup-en [2020/05/22 08:00] – [DCC] rjversluis | ||
---|---|---|---|
Line 77: | Line 77: | ||
It will power off automatically in case no DCC signal is detected.\\ | It will power off automatically in case no DCC signal is detected.\\ | ||
- | ===Fast PT=== | + | ===RailCom=== |
- | Only send one reset and one programming | + | Enable RailCom cutout in the preamble |
- | Disable this option | + | Disable this option |
\\ | \\ | ||
====Mobile servo PWM==== | ====Mobile servo PWM==== |
arduino/wio-setup-en.txt · Last modified: 2024/04/07 11:14 by rjversluis