besra:german:test
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
besra:german:test [2020/12/03 15:24] – [Setting up the CS2 / CS3 in Rocrail] besra | besra:german:test [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Test Schriftgröße ===== | ||
- | Normaler Text, wie er im Wiki verwendet wird. | ||
- | |||
- | < | ||
- | <span style=" | ||
- | </ | ||
- | |||
- | \\ | ||
- | ===== Test Signal-Übersicht nach Typ ===== | ||
- | |< >| | ||
- | | ^ Formsignale | ||
- | ^ \\ \\ Hp0 / \\ Hp00 | {{sig: | ||
- | | \\ \\ \\ **Hp1** | ||
- | ^ \\ \\ \\ Hp2 | || {{sig: | ||
- | | \\ \\ \\ **Sh1** | ||
- | ^ | Block- | ||
- | |||
- | \\ | ||
- | ===== Test Signal-Übersicht nach Einsatz ===== | ||
- | |< >| | ||
- | | ^ Blocksignale | ||
- | ^ \\ \\ Hp0 / \\ Hp00 | {{sig: | ||
- | | \\ \\ \\ **Hp1** | ||
- | ^ \\ \\ \\ Hp2 | |||| {{sig: | ||
- | | \\ \\ \\ **Sh1** | ||
- | |||
- | |||
- | ===== Spezielles: Test ===== | ||
- | |||
- | ===== | ||
- | =====MBUS CS3==== | ||
- | |||
- | ===== Setting up the CS2 / CS3 in Rocrail ===== | ||
- | After starting Rocrview, create a new or open an existing workspace as described in **[[: | ||
- | Prepare adding the command station as described in **[[: | ||
- | |||
- | After the virtual command station was deleted according to the instructions linked above, select **mbus** from the drop-down menu **New**. The slected command station is added by pressing **Add**. \\ | ||
- | A new command station with Interface ID '' | ||
- | The **Interface ID** '' | ||
- | The **Type** has to be set to **TCP**. The **Hostname** is the IP address of the CS2/CS3 and has to be entered here. After the colon add '' | ||
- | **Device**, **Baudrate** and **CTS** should stay unchanged. **Protocol**s not required can be unchecked, if necessary. \\ | ||
- | After closing both the mbus dialogue and the properties dialogue with **OK** Rocrail has to be restarted. | ||
- | |||
- | To check the configuration after the restart, the workspace that was edited before is opened again. With the CS2 / CS3 started and in Stop mode track power can be switched on and off by the lightbulb symbol in the tool bar. If the command station responds to this test, the setup is complete. \\ | ||
- | Additional check: After opening //Menu -> Programming -> CANBUS// the CS and the GFP should be displayed in the list. | ||
- | |||
- | |||
- | |||
besra/german/test.1607005491.txt.gz · Last modified: 2020/12/03 15:24 by besra