Differences

This shows you the differences between two versions of the page.

--- bidib-en [2020/04/29 09:56] – rjversluis
+++ bidib-en [2023/10/29 09:57] (current) – [Options] rjversluis
@@ Line 7: / Line 7: @@
- \\
-[[http://www.bidib.org/|{{http://www.bidib.org/pics/bidib_logo.png?150|BiDiB, ein universelles Steuerprotokoll für Modellbahnen}}]] \\
-===== General information =====
-{{ http://www.opendcc.de/bidib/overview/bidib_system.png?400}}
-BiDiB is a protocol which supports P&P with a high reliability communication level.\\
-For more information:
-  * http://bidib.org/
-    * [[http://www.bidib.org/protokoll/bidib_general.html#T13|License DE]] [[http://www.bidib.org/protokoll/bidib_general_e.html#T13|EN]]
- \\
-//Rocrail is a BiDiB licensee.//\\
  \\
@@ Line 34: / Line 23: @@
  \\
-if sensor and input types at the same board exist the sensor range is 1 .. 128 and the input types are at 201 .. 328.
+if sensor and input types at the same board exist the sensor range is 1 .. 128 and the input types are at 201 .. 328.\\
+**Tip:** Use the [[:sensormon-en|Sensor Monitor]] to find the right address.\\
 ===== Important Options=====
@@ Line 113: / Line 105: @@
 ==== Options ====
-{{:bidib:bidib-setup-options-en.png}}\\
+{{:bidib:bidib-setup-options-en.png?600}}\\
 === Secure ACK ===
 ==Activate==
@@ Line 126: / Line 118: @@
 === Report absent ===
 If this option is activated, it will be reported if a loco ID is no longer recognized by a RailCom detector.
+  \\
+=== Query inputs ===
+Query also inputs at "Start of Day".\\
+Only modules which are reporting number of inputs > 0 and using the Flat port model.\\
+===Wizard===
+The TCP Port for the BiDiB-Wizard.\\
+If multiple masters are connected to this computer, every library must have its own unique port.\\
   \\
 === Watchdog ===
@@ Line 168: / Line 169: @@
 Starting with firmware 2.1.4 the GBMBoost Master can be used as Programming Track.\\
 Before programming on the PT the PT-Mode must be set, see the __**[[:pt-en#pt|PT Button]]**__ on the Programming Tab.\\
- \\
-The GBM16T with Firmware 2.1.1 must be disconnected from the GBMBoost-Master or set into reset mode:\\
-{{:bidib:reset_gbm16t.png?400}}\\
  \\
@@ Line 176: / Line 174: @@
 =====BiDiB Wizard=====
 The Wizard can be connected to TCP port 62875 to configure nodes.\\
-The [[:rocgui-menu-en#enable_communication|Communication must be disabled]] before port 62875is serviced.\\
+The [[:rocgui-menu-en#enable_communication|Communication must be disabled]] before port 62875 will be serviced.\\