Differences

This shows you the differences between two versions of the page.

--- dr5000-en [2019/01/27 19:34] – [Devices] smitt48
+++ dr5000-en [2020/05/31 07:55] – [Z21] rjversluis
@@ Line 22: / Line 22: @@
 **After successful configuration, several other commonly used protocol types can be used with Rocrail.**
  \\
+====Setup USB LocoNet Rocrail====
+{{:dr5000:rocrail_controller_dr5000-en.png|}} \\
+{{:dr5000:dr5000_loconet_interface-en.png?281|}} {{:dr5000:dr5000_loconet_options-en.png?281|}} {{:dr5000:dr5000_loconet_details-en.png?281|}} \\
+More details are described below. \\
 ====Setup LAN====
 LocoNet, LNTCP, is recommended for the DR5000 communication. (Xpressnet seems to be too slow and is missing some events.)\\
@@ Line 41: / Line 47: @@
 ===Type===
 The **LNTCP** type must be selected for this communication protocol.\\
+Rocrail will expect an echo for every command in case **CTS** is set active. \\
+(Error message: Trace timer timed out for OPCODE 0xB0, to fix: increase timer)\\
+- the time between switching on the system and starting Rocrail is too short, the DR 5000 should be left for a few moments until everything is ready for operation. \\
 ===Options===
 Some LocoNet Throttles do not set an ID and therefore the Speed will not be updated in the Rocrail clients. (Rocview, andRoc, Rocweb...)\\
@@ Line 61: / Line 69: @@
  \\
 ====Z21====
+See for Z21 settings __**[[:roco:roco-z21-en|Roco Z21]]**__.\\
 ===DR5088RC===
 If using the Z21 protocol in combination with DR5088RC there is a shift in reported feedback and block(RailCom) addressing.\\