dtc-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
dtc-en [2019/04/12 10:18] – rjversluis | dtc-en [2019/11/18 15:40] (current) – removed rjversluis | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Dinasys Turntable Controller ====== | ||
- | [[: | ||
- | [[: | ||
- | \\ | ||
- | \\ | ||
- | {{: | ||
- | \\ | ||
- | ===== Introduction ===== | ||
- | This CS is to control one turntable with the **D**inasys **T**urntable **C**ontroller.\\ | ||
- | The Rocrail definition must be set to protocol **Multiport** and **Interface-ID** pointing to this controller.\\ | ||
- | \\ | ||
- | ===== Setup ===== | ||
- | All parameters are ignored except for **IID**, **Port** and **Version**. | ||
- | |||
- | ==== Port ==== | ||
- | The serial device name connected to the DTC.\\ | ||
- | |||
- | ==== Options ==== | ||
- | ^ Version ^ Turntable Type ^ | ||
- | | 0 | Default | | ||
- | | 1 | DTC 48 tracks | | ||
- | | 2 | DTC 24 tracks | | ||
- | | 3 | DTZ 24 tracks 15° | | ||
- | |||
- | \\ | ||
- | =====Position sensor===== | ||
- | If the end position has been reached it will be reported by sensor address **10001**.\\ | ||
- | See: __**[[: | ||
- | |||
- | \\ | ||
- | |||
- | =====Protocol===== | ||
- | {{: |
dtc-en.1555057117.txt.gz · Last modified: 2019/04/12 10:18 by rjversluis