User Tools

Site Tools


gca-wio-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
gca-wio-en [2020/01/13 11:31] – typo smitt48gca-wio-en [2020/02/08 11:46] – [Switching Power supply] phg
Line 27: Line 27:
 But making a 5 Volt power line, is not a good idea.\\ But making a 5 Volt power line, is not a good idea.\\
 The power loss in many occasions might come unacceptable for a certain task, like servo's.\\ The power loss in many occasions might come unacceptable for a certain task, like servo's.\\
-Therefore, this board is equipped with a switching regulator, and the power supply for this unit can be anything between 12 and 24 Volt ac or dc.\\ +Therefore, this board is equipped with a switching regulator, and the power supply for this unit can be anything between 12 and 24 Voltdc or between 10 and 18 Volt ac.\\ 
-The wotsl VA (Volt x Ampere) should be at least 20 VA.\\ +The total VA (Volt x Ampere) should be at least 20 VA.\\ 
-So also a transformer is useful here.\\+So also a normal train transformer is useful here.\\
 The switching regulator has a selection for the output voltage, which should be set to 5V.\\ The switching regulator has a selection for the output voltage, which should be set to 5V.\\
 It can be done by the on-board trimmer, but I prefer to use the voltage selector on the bottom side of the regulator board.\\ It can be done by the on-board trimmer, but I prefer to use the voltage selector on the bottom side of the regulator board.\\
gca-wio-en.txt · Last modified: 2021/02/25 18:58 by phg