gca102-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
gca102-en [2019/03/27 10:19] – [Remarks on GCA102v3 used with hall sensors] peter_basti | gca102-en [2020/04/22 19:06] – [Remarks on GCA102v3 used with hall sensors] phg | ||
---|---|---|---|
Line 141: | Line 141: | ||
Board needs 5Volt supply to pin1&2 of J2, and pin3 and 4 are control inputs.\\ | Board needs 5Volt supply to pin1&2 of J2, and pin3 and 4 are control inputs.\\ | ||
See partslist for GCA102V3\\ | See partslist for GCA102V3\\ | ||
- | 1 hall sensor | + | Hall sensors |
- | that a hall sensor | + | that one of these hall sensors |
- | {{: | + | H1 and H2 are positioned at both sides of separation cut left,\\ |
+ | H3 and H4 are positioned at both sides of the other separation.\\ | ||
gca102-en.txt · Last modified: 2021/02/12 17:40 by rjversluis