User Tools

Site Tools


gca102-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
gca102-en [2019/07/04 12:00] – [Remarks on GCA102v3 used with hall sensors] phggca102-en [2020/04/22 19:13] phg
Line 141: Line 141:
 Board needs 5Volt supply to pin1&2 of J2, and pin3 and 4 are control inputs.\\ Board needs 5Volt supply to pin1&2 of J2, and pin3 and 4 are control inputs.\\
 See partslist for GCA102V3\\ See partslist for GCA102V3\\
-1 hall sensor should be positioned on both sides of both rail separation cuts., with a distance so,\\ +Hall sensors should be positioned at each side of both rail separation cuts., with a distance so,\\ 
-that hall sensor is activated BEFORE first wheels are approaching the rail cuts.\\ +that one of these hall sensors is activated BEFORE first wheels are touching the rail cuts.\\ 
- +H1 and H2 are positioned at both sides of separation cut left,\\ 
 +H3 and H4 are positioned at both sides of the other separation.\\ 
 +Simple tip: 
 +If you experience ALWAYS a short cut when train is running into the loop, there are 2 simple solutions:\\ 
 +     * 1. swap the rail connections between the loop rails and GCA102. 
 +     * 2. swap H1 with H3, and swap H2 with H4.\\ 
 +One of these will be your solution.\\
  
  
gca102-en.txt · Last modified: 2021/02/12 17:40 by rjversluis