Differences

This shows you the differences between two versions of the page.

--- gca107-en [2018/11/12 08:56] – external edit 127.0.0.1
+++ gca107-en [2020/05/28 13:57] (current) – [Description] phg
@@ Line 13: / Line 13: @@
 [[mgv76-en|GCA76]] and [[mgv77-en|GCA77]] are suitable to switch these units, but only with DC.\\
 Also to be able to switch a frog on a turnout, a relay is mostly the only way to do it in a reliable way.\\
-Relayboard [[mgv137-en|GCA137]] is made for that purpose only, but it will not suit the GCA-PIxx Raspberry units.\\
+Relayboard [[mgv137-en|GCA137]] is made for that purpose only, but it will not suit the GCA-PIxx RocNet units.\\
 The relay board as presented here, is a more universal module.\\
 It contains 8 relays, which can be used for various situations.\\
@@ Line 22: / Line 22: @@
 Selection of different tasks is made by a set of 5 jumpers with each pair of relays.\\
 The maximum current demand for this board with all relays activated = 240 mA.\\
-In most situations only have of the rlays are switched on, with pulse output almost none.\\
+In most situations only half of the relays are switched on, with pulse output almost none.\\
-It should be considered with this the total current, that a voltage regulator on either CAN-GC2 board or GCA50 shpuld be able to handle that..\\
+It should be considered with this the total current, that a voltage regulator on either CAN-GC2 board or GCA50 should be able to handle that..\\
 Be sure on these boards that 5V regulator IC is mounted with nut in between pc-board and IC, to improve cooling.\\
 This is also mentioned on the partslist.\\
-If it is used with GCA_PI02, it needs an adequate supply like GCA_PI06.\\
+If it is used with GCA_PI02, the RocNet network needs an adequate supply like GCA_PI06.\\
  \\
 Professional made boards are available.\\
-Single boards or complete kits.  See {{www.phgiling.net|GCA}} \\
+Single boards or complete kits.  See [[GCA:gca-index-en|GCA]] \\
  \\