gca214-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
gca214-en [2020/02/15 19:51] – [GCA214 Loc Identification Receiverr for WIO] phg | gca214-en [2023/07/09 07:47] (current) – rjversluis | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ======GCA214 Loc Identification | + | ======GCA214 Loc Identification |
[[english|{{ | [[english|{{ | ||
+ | * [[: | ||
+ | * [[: | ||
+ | * [[: | ||
- | [[english|Content]] -> [[hardware-en|Hardware]] -> [[hardware-en# | ||
- | + | {{ : | |
- | {{ : | + | {{ : |
\\ | \\ | ||
Line 15: | Line 17: | ||
The basic reason for that was that a microprocessor is no longer needed.\\ | The basic reason for that was that a microprocessor is no longer needed.\\ | ||
The WIO (Ctrl) where it is connected to, contains a much more powerful processor to translate the LIR (Loc Identification Receiver) data.\\ | The WIO (Ctrl) where it is connected to, contains a much more powerful processor to translate the LIR (Loc Identification Receiver) data.\\ | ||
- | Furthermore this unit can handle up to 3,5 Amp, so there is no damage | + | Furthermore this unit can handle up to 3,5 Amp, so there is no damage |
The serial output of GCA214 is made with an Opto-coupler, | The serial output of GCA214 is made with an Opto-coupler, | ||
It is connected to a serial input of the WIO system.\\ | It is connected to a serial input of the WIO system.\\ |
gca214-en.1581792667.txt.gz · Last modified: 2020/02/15 19:51 by phg