Differences

This shows you the differences between two versions of the page.

--- intellibox-basic-en [2018/11/15 10:12] – [Product Overview] rjversluis
+++ intellibox-basic-en [2019/12/04 13:46] – [Reset the device] vt601
@@ Line 3: / Line 3: @@
 [[english|Content]] -> [[english#Command Stations|Command Stations]] -> **Uhlenbrock**
-  * [[intellibox-en|IntelliBox]] | **IntelliBox Basic, Intellibox II and USB-LocoNet Interface**
+  * [[intellibox-en|IntelliBox]] | **IntelliBox Basic, Intellibox II and USB-LocoNet Interface (ULNI)**
 // \\ // \\
@@ Line 44: / Line 44: @@
 {{:ib:loconet-options-en.png}}\\
 Set the CS Type: **intellibox** or **ibcom** for functions support > 8. \\
-On tab //Options// there are no adjustments available for the IB.\\
+On tab //Options// there are no adjustments available for the IB. The options tab is only for Digitrax.\\
 > **Note:** \\ For the IBCom, the IB-Basic and the IB II, the value "ibcom" in the options-dialog has to be set. Otherwise, programming of decoders in Rocrail will not work (Programming Track).
@@ Line 172: / Line 172: @@
  \\
-:!: LocoNet direct mode __has to be switched off__! \\
+:!: De LocoNet direct mode __moet uitgeschakeld zijn__! \\
-Since the software handshake itself requires part of the bandwidth available the highest possible baud rate (115200) should be used in order not to slow down communication speed. \\
+Omdat voor de software handshake een deel van de beschikbare bandbreedte noodzakelijk is, moet de hoogst mogelijke baudrate (115200)worden gebruikt. Hiermee wordt de communicatie snelheid maximaal benut.\\
  \\