loconet:dtopsw-en
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | loconet:dtopsw-en [2018/11/12 08:56] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Option Switches ====== | ||
+ | [[: | ||
+ | [[: | ||
+ | * [[: | ||
+ | // \\ // \\ | ||
+ | Digitrax uses **Option Switches** to setup stationary decoders. They can be set by standard switch commands or with special LocoNet commands.\\ | ||
+ | Rocrail supports with this dialog reading and writing of Option Switches for the following decoders: | ||
+ | * **BDL16x**: current sensors and transponder receiver | ||
+ | * **DS64**: switches | ||
+ | * **SE8**: switches and signals | ||
+ | \\ | ||
+ | | The target decoder must be set in programming mode before option switches can be changed; See manual. |\\ | ||
+ | |||
+ | \\ | ||
+ | ===== Option Switches Dialog ===== | ||
+ | {{: | ||
+ | |||
+ | \\ | ||
+ | ==== Address ==== | ||
+ | This is the board address of the decoder.\\ | ||
+ | This address cannot be changed with this dialog, you need to check the manual for this.\\ | ||
+ | |||
+ | \\ | ||
+ | ==== Type ==== | ||
+ | Select the wanted board type to program.\\ | ||
+ | |||
+ | \\ | ||
+ | ==== Option Switches List ==== | ||
+ | Each board type has its own set of option switches as is listed after type selection.\\ | ||
+ | |||
+ | \\ | ||
+ | ==== Read All ==== | ||
+ | Read all the option switches from the address and type set for the board.\\ | ||
+ | |||
+ | \\ | ||
+ | ==== Write All ==== | ||
+ | Write all the option switches from the address and type set for the board.\\ |
loconet/dtopsw-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1