This is an old revision of the document!
Table of Contents
MBUS CS3
TCP Communication
Note: Only direct TCP communication with the CS2/CS3 is supported in the Rocrail Forum. |
---|
IP Address
The CS3 has DHCP active by default, and will get an IP address from router (In this example a FritzBox.):
The host name, in this example CS3-06294, can be used in Rocrail instead of using the IP address,
Communication Type
The preferred way to communicate with the CS3 is by using the TCP type.
The CS3 TCP port is factory set to 15731.
Overview
Sensors
Poll at SoD
Use only in case of Gleisreporter de Luxe.
Poll
Use only in case of Gleisreporter Basic.
S88 CS2/CS3plus
This setup is needed to be able to detect the sensor state at start up.
Check the CS3 System setup for ID and number of connected modules.
ID
"Kennung"1)
The S88 Device ID to use for 'Start of Day'.
This ID is also the reported bus value.
Modules
"Länge S88 Bus"2)
The number of connected 16 port S88 modules.
LinkS88
Starting with revision 15.073, this setup is no longer needed; Its detected automatically. |
This setup is needed to be able to detect the sensor state at start up.
An entry in the list is needed for each connected LinkS88 device.
Check the CS3 System setup for ID and number of connected modules.
Options
See: MBUS Options
Acknowledge sensor events
This option only has effect in case the GC2a is used for sensor detecting.
It will only acknowledge the high state of sensor events.
Turn this option off in all other cases.
Addressing
Switch/Output
An example for CS2/3 switch address 11:
Type | Address | Port | Calculation |
---|---|---|---|
MADA | 3 | 4 | (3-1)*4+(4-1)=11 |
PADA | - | 123) | 12-1=11 |
Loco List/Discover
Rocview → Control → Discover |
The Discover command can be used to get the locos from the CS2/CS3.
New discovered locos during the session are automatically added to Rocrail.
WEB Service
The CS3 has a build in WEB service which can be viewed with the following URL:
http://cs3-06294
Where cs3-06294 is the host name of the CS3.
The WEB service provides the following facilities:
- Help
- Setup
- App Service
- And more…