mbus:mbus-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mbus:mbus-en [2019/01/14 19:29] – [MBUS] rjversluis | mbus:mbus-en [2019/01/17 20:15] – rjversluis | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== MBUS ====== | ====== MBUS ====== | ||
[[: | [[: | ||
- | [[: | + | [[: |
\\ | \\ | ||
- | | | + | | |
\\ | \\ | ||
=====Introduction===== | =====Introduction===== | ||
Line 75: | Line 75: | ||
This output addressing can be used for activating a relay before programming.\\ | This output addressing can be used for activating a relay before programming.\\ | ||
The TrackBox does not provide a separate output for programming. To avoid programming all locomotives on the main track, it can be helpful to switch to the isolated programming track.\\ | The TrackBox does not provide a separate output for programming. To avoid programming all locomotives on the main track, it can be helpful to switch to the isolated programming track.\\ | ||
+ | |||
+ | \\ | ||
+ | =====Accessory Addressing===== | ||
+ | ====DCC/ | ||
+ | All addressing schemes are supported. (FADA/ | ||
+ | The bus value **must** be set to zero.\\ | ||
+ | ====GC2a==== | ||
+ | * Bus = CAN-ID | ||
+ | * Address = GC2a port number, 1...16 | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====GC2a Signal support===== | ||
+ | This is for simple signals up to 4 LED and max. 5 aspects.\\ | ||
+ | Only the RED address will be used as offset for all LEDs.\\ | ||
+ | |< >| | ||
+ | ^ Parameter ^ Description ^ | ||
+ | | Control | Aspect numbers | | ||
+ | | Port type | LED | | ||
+ | | Bus | CAN-ID of the GC2a | | ||
+ | | Addressing | FLAT from 1 to 16 - number of aspects | | ||
+ | |||
+ | ====Aspect Values==== | ||
+ | See: __**[[: | ||
+ | The number of controlled LEDs will be calculated from the aspect values.\\ | ||
+ | |||
+ | ===Example=== | ||
+ | ===Aspect value examples=== | ||
+ | |< >| | ||
+ | ^ Value (dec) ^ LEDs ^ | ||
+ | | 0x01 (1) | LED 1 on | | ||
+ | | 0x02 (2) | LED 2 on | | ||
+ | | 0x04 (4) | LED 3 on | | ||
+ | | 0x08 (8) | LED 4 on | | ||
+ | | 0x11 (17) | LED 1 blinking | | ||
+ | | 0x55 (85) | LED 1 and 3 blinking | | ||
+ | | 0x03 (3) | LED 2 and LED 1 on | | ||
+ | | 0x13 (19) | LED 2 on and LED 1 blinking | | ||
+ | |||
\\ | \\ |
mbus/mbus-en.txt · Last modified: 2022/02/10 22:05 by rjversluis