Table of Contents
GCA106 MGV-Loconet to standard Loconet Gender
Description
There were some remarks about how to connect FredI, Lissy and other items to the D-con-loconet system.
This unit provides four RJ12 connectors.
Common for all connectors there is a choice of having the power supplied to the connector or not.
Connecting power stations like Digitrax DCS100 or Intellibox, the power jumper is to be removed.
The latest version is made adaptable to GCA108, where Railsync lines are connected to D-connectors.
All diodes are removed, and only 1 jumper is left.
Remark.
This board is only for D.I.Y. No board will be available.
Board CAN-GCLN, just connectors mounted, is having the same options, and is available as ready made board.
The prototype assembled
The files
The PC-board can be made single sided, by using wires on toplayer.
IMPORTANT NOTE Jumper JP1 should only be used, when only MGV85 or MGV101 is connected in the Loconet. On connection of Digitrax centrals/booster or Intellibox or any other central unit, no jumper should be set!
Bill of materials
ref | part | descr. | dealer |
Led1 | Led 3mm | Led 3mm | |
R1 | 2K2 | resistor | |
J1 | d-connector Male 9 pins | D-SUB ST 09EU | Reichelt |
J2 | d-connector Female 9 pins | D-SUB BU 09EU | Reichelt |
J3..J6 | RJ12 connector | Mod6G | Darisus |
JP1 | 2 pin header |
This is a D.I.Y. project.. No boards available.