Differences

This shows you the differences between two versions of the page.

--- raspi:raspi-dev-en [2019/04/20 16:21] – rjversluis
+++ raspi:raspi-dev-en [2022/12/10 18:18] (current) – rjversluis
@@ Line 1: / Line 1: @@
+[[:english|{{  :rocrail-logo-35.png}}]]
 ======RasPi======
-[[:english|{{  :rocrail-logo-35.png}}]]
+[[:develop:develop-corner-en|Compile & Build]] -> **[[:develop:develop-corner-en##debian_pios|Debian & PiOS]]**
-  * [[:develop-corner-en|Developer Corner]]
+ \\
-    * **[[:develop-corner-en#compile_rocrail|Build from source]]**
-    * >> [[:rocnet:rocnetnode-en|RocNetNode]] <<
  \\
 [[http://raspberrypi.org|{{http://www.raspberrypi.org/wp-content/uploads/2012/03/Raspi_Colour_R.png?50}}]] [[http://raspberrypi.org|“Raspberry Pi" is a trademark of the Raspberry Pi Foundation.]]\\
-[[http://www.raspberrypi.org|{{http://www.raspberrypi.org/wp-content/uploads/2012/04/Screen-Shot-2012-12-24-at-10.59.55-1024x722.png?400}}]]\\
-{{ :raspi:raspberry-pi-rrbuild.png?300}}
-===== Install additional packages=====
-<code>
-sudo apt-get install libwxgtk3.0-dev
-sudo apt-get install libusb-1.0-0-dev
-</code>
-The wxWidgets library, libwxgtk3.0-dev, is only needed if Rocview should be build too. (Approximately total build time is < 10 minutes under Jessie on a Raspberry Pi 3)\\
  \\
 ===== Install pre-build package =====
-Pre-build packages (nightly build) can be found here:
+Pre-build packages (daily build) can be found here:
   * https://rocrail.net/software/rocrail-snapshot/
@@ Line 86: / Line 77: @@
 =====Documentation=====
-  * [[userpages:pirat-kapitan:rocrail-auf-raspi3-en-short|Install pre-build package on a RasPi 3]]\\
+  * [[raspi:install:rpi-install-en|Install pre-build package on a RasPi]]\\
-  * [[userpages:pirat-kapitan:rocrail-auf-raspi|Rocrail auf einem RasPi installieren (German only)]]\\
    \\
@@ Line 113: / Line 103: @@
-===== Links =====
-  * http://www.raspberrypi.org
-  * [[http://elinux.org/RPi_Easy_SD_Card_Setup|SD Card Setup]]
-  * [[http://elinux.org/RPi_Low-level_peripherals|I/O]]
-  * [[http://wiringpi.com|WiringPi C Library]]
-    * https://github.com/WiringPi/WiringPi/tree/master/wiringPi
-  * http://learn.adafruit.com/setting-up-a-raspberry-pi-as-a-wifi-access-point/overview
-  * I2C: http://www.raspberrypi-spy.co.uk/2013/07/how-to-use-a-mcp23017-i2c-port-expander-with-the-raspberry-pi-part-1/
-  * I2C C++: http://hertaville.com/2013/04/01/interfacing-an-i2c-gpio-expander-mcp23017-to-the-raspberry-pi-using-c/
-  * I2C: http://elinux.org/Interfacing_with_I2C_Devices
- \\