rocnet:sw-servo-setup-en
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | rocnet:sw-servo-setup-en [2018/11/12 08:56] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== RocNetNode Servo Switch Setup ====== | ||
+ | [[: | ||
+ | [[: | ||
+ | * [[rocnet: | ||
+ | * [[: | ||
+ | * [[: | ||
+ | |||
+ | |||
+ | \\ | ||
+ | \\ | ||
+ | =====The example===== | ||
+ | This example shows how to setup a switch controlled by a **[[: | ||
+ | * Interface | ||
+ | * Field feedback (Wiring) | ||
+ | * Frog polarisation. | ||
+ | |||
+ | |||
+ | \\ | ||
+ | |||
+ | =====General===== | ||
+ | {{: | ||
+ | |||
+ | \\ | ||
+ | =====Interface===== | ||
+ | Set the bus to the RocNetNode-ID, | ||
+ | {{: | ||
+ | |||
+ | \\ | ||
+ | =====Wiring===== | ||
+ | The **[[: | ||
+ | | Only set **Use field events** for this servo controlled switch. | The __**[[: | ||
+ | | {{: | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====Frog===== | ||
+ | Just set the two relay addresses for frog 1.\\ | ||
+ | These addresses are most likely located on a **[[: | ||
+ | {{: | ||
rocnet/sw-servo-setup-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1