roco:roco-z21-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
roco:roco-z21-en [2018/12/08 07:53] – [Accessories] rjversluis | roco:roco-z21-en [2019/01/07 12:18] – [Power Manager] rjversluis | ||
---|---|---|---|
Line 78: | Line 78: | ||
^ Bus ^ Network ^ Z21 Firmware ^ Remark ^ | ^ Bus ^ Network ^ Z21 Firmware ^ Remark ^ | ||
| 0 | R-Bus | 1.0 | | | | 0 | R-Bus | 1.0 | | | ||
- | | 1 | LocoNet | + | | 1 | LocoNet | 1.2 | LocoIO, DR5088RC(Feedback), GBM16XN, DR5088RC(Block) | |
- | | 1 | LocoNet Multi Sense | 1.2 | GBM16XN, DR5088RC(Block) | | + | |
| 3 | CAN | 1.29 | Roco Z21 CAN Detector | | | 3 | CAN | 1.29 | Roco Z21 CAN Detector | | ||
===Flat addressing=== | ===Flat addressing=== | ||
Line 86: | Line 85: | ||
...\\ | ...\\ | ||
\\ | \\ | ||
- | |||
====Special Feature ==== | ====Special Feature ==== | ||
In the default setting of the z21 / Z21 there is an address offset of +4 between Multimaus and Rocrail. This means that in Rocrail the addresses 1-4 can not be used. If e.g. address 1 of the multimouse is to be used in Rocrail address 5. But there is an elegant way to eliminate this shift. To do this, connect the z21 to the computer via the z21-maintenance-tool, | In the default setting of the z21 / Z21 there is an address offset of +4 between Multimaus and Rocrail. This means that in Rocrail the addresses 1-4 can not be used. If e.g. address 1 of the multimouse is to be used in Rocrail address 5. But there is an elegant way to eliminate this shift. To do this, connect the z21 to the computer via the z21-maintenance-tool, | ||
\\ | \\ | ||
- | =====Rocrail & GBM16XN===== | + | =====GBM16XN===== |
+ | | :!: **Activate only in case of GBM16XN detectors!** | | ||
+ | This option will activate evaluating LAN_LOCONET_DETECTOR messages to support the GBM16XN detectors.\\ | ||
+ | The reported input address is increased with one to meet the GBM16XN settings. This conflicts with normal LocoNet!\\ | ||
Z21 firmware: 1.24+\\ | Z21 firmware: 1.24+\\ | ||
- | See for setup: http:// | ||
\\ | \\ | ||
+ | ===== Power Manager===== | ||
+ | To add the Z21 to the __**[[: | ||
+ | {{roco: | ||
+ | The address is fixed to 21.\\ | ||
+ | {{roco: | ||
+ | |||
+ | |||
+ | \\ | ||
===== Trouble Shooting ===== | ===== Trouble Shooting ===== | ||
==== LAN ==== | ==== LAN ==== |
roco/roco-z21-en.txt · Last modified: 2023/05/15 09:33 by cds