Differences

This shows you the differences between two versions of the page.

--- sensor-int-en [2018/11/12 08:56] – external edit 127.0.0.1
+++ sensor-int-en [2021/03/25 12:42] – [Type] smitt48
@@ Line 10: / Line 10: @@
 SensorDialog Interface Tab.\\
-{{:sensor-int-en.png}}\\
+{{:sensor-int-en.png?500}}\\
  \\
@@ Line 24: / Line 24: @@
  \\
+=====RFID=====
+The 32bit RFID number printed on the Tags. (Leading zeros can be left out.)\\
+This can be used in combination with __**[[:arduino:wio-en#id-12la|WIO-Drive and an ID-12LA reader]]**__.\\
+All other addressing, like Node ID and Address, are ignored if the RFID did match. (But an additional fake address makes it possible to check the plan virtually.)\\
+{{:wio:rfid32.jpg?600}}\\
+Example of the blue Tag scan:\\
+{{:wio:rfid-index.jpg}}
+<code>
+OWIO     0885 Mobile 18 [BR218] RFID event [12.0.197.167.148] [12953492]
+OModel   5329 trying to match sensor event: [WIO] id=[12.0.197.167.148] 0:0 uidname=[] state=0 code=BR218 regval=0 info=
+OFBack   0796 fb[s18-] state=ON code=BR218 dir=0 val=0 count=5 regval[0]=0
+</code>
 =====Bus=====
@@ Line 67: / Line 80: @@
 =====Type=====
-^ Value  ^ Type  ^ Manu ^ Remark  ^
+|< >|
+^ Value  ^ Type  ^ Manufacturer ^ Remark  ^
 | 0 | Current sensors | - | Most commonly used; Can also report bi-directional information; Also for Hall Sensors when not used as wheel counters. |
 | 1 | IR Lissy | Uhlenbrock | Can be used with the __**[[:sensor-gen-en#timer|Off timer]]**__ to get it unoccupied. |
@@ Line 76: / Line 90: @@
 | 6 | Wheel counter | **[[:gca173-en|GCA173 Hall Sensors]]**, **[[:mgv141-en|GCA141]]** | Used for wheel or car counting. |\\
 | 7 | GPS | **[[:got:got-en|GamesOnTrack]]** | Using the GPS coordinates on the GPS tab. |
-| 8 | Register | - | Can be used for __**[[:turntable-int-en#position_sensors|Turntable position sensor]]**__. (Selectrix based systems)  |
+| 8 | Register | - | Can be used for __**[[:turntable-int-en#position_sensors|Turntable position sensor]]**__.  |
 Read **[[sensor-bi-directional-en|Bi-Directional Communication]]** for more information on this topic.\\
  \\
+=====Register trigger=====
+Specifies the physical quantity for which the value represented by the register bits is defined.
 ===== Options =====
 ==== Active low ====
@@ Line 94: / Line 107: @@
 ==== Threshold ====
 The minimal value to signal the sensor high in case of type register.\\
+=====Note=====
+For the assignment of addresses to sensor\feedback in the track plan, there is help with **[[sensormon-en#Tip for the assignment of addresses to sensors\feedback in a track plan|Sensor Monitor]]** \\
+ \\