signal-int-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
signal-int-en [2020/04/04 08:19] – [Patterns] rjversluis | signal-int-en [2021/10/26 21:50] – [Aspect numbers] rjversluis | ||
---|---|---|---|
Line 39: | Line 39: | ||
* LEDii | * LEDii | ||
* WIO (WIP) | * WIO (WIP) | ||
- | \\ | + | |
+ | ====Parameter==== | ||
+ | Special settings for some Command Stations: | ||
+ | * **[[: | ||
+ | \\ | ||
===== Control ===== | ===== Control ===== | ||
Line 48: | Line 52: | ||
Signal decoders are most likely controlled with patterns on two or three ports. The patterns are set up on the **__[[signal-props-en# | Signal decoders are most likely controlled with patterns on two or three ports. The patterns are set up on the **__[[signal-props-en# | ||
See __**[[: | See __**[[: | ||
- | **Note:** Patterns can only be used with MADA addressing, and max. 5 aspects.\\ | + | **Note:** Patterns can only be used with PADA/MADA addressing, and max. 5 aspects. |
Line 55: | Line 59: | ||
The following Command Stations are supported: | The following Command Stations are supported: | ||
* [[: | * [[: | ||
- | * [[: | + | * [[: |
- | * [[: | + | * [[: |
* [[: | * [[: | ||
- | * [[: | + | * [[: |
* [[: | * [[: | ||
* [[: | * [[: | ||
* [[: | * [[: | ||
* [[: | * [[: | ||
+ | * [[: | ||
| | ||
- | ¹) [[http:// | + | |
==== Linear ==== | ==== Linear ==== | ||
Uses only the first address as offset to control all aspects. (Only for FADA/ | Uses only the first address as offset to control all aspects. (Only for FADA/ |
signal-int-en.txt · Last modified: 2023/09/12 08:11 by rjversluis