Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+======Turntable======
+[[:english#objects|{{  :objects.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
+[[english|Content]] -> [[english#objects|Objects]] ->   **Turntable**
+  * [[turntable-index-en|Index]] | [[turntable-gen-en|General]] | [[turntable-int-en|Interface]] | [[turntable-tracks-en|Tracks]] | [[turntable-setup-en|Setup]] | [[traverser-setup-en|Traverser setup]]
+ \\
+{{  draaischijf.jpg}}\\
+=====Sensors=====
+To provide Rocrail with events you must add some sensors to the turntable.
+On most turntable you can add without much affort those sensors: [[turntable_locdec_en]]
+In the worst case you can use reed schwitches in combination with magnets. But any how it is up to you to find the best solution for your turntable.
+====Bridge Position====
+Needed for displaying and auto mode.
+====Bridge Occupancy====
+For generating the **enter** and **in** event.
+The most common way ist to split up the bridge track into two equals occupancy sections, but its only at one rail necessary. (One side of the Bridge track). Alternatively, two Point sensors can be used near the ends of the Bridge track.\\
+For the triggering and assignment of the events see: __**[[turntable-int-en#bridge_sensors_1_to_4|Turntable: Interface]]**__
+|< >|
+| {{turntable-2-sections.jpg}} |
+|  Only the rail at one side is divided into 2 sections. \\ This Fleischmann 6652 turntable is also converted from K-Rail \\ to Tillig Code 83 and features 6 contacts, but only 4 are needed.  |