Innovative Model Railroad Control System

User Tools

Site Tools

Trace:
users:dagnall53:rocclienttool

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
Last revisionBoth sides next revision
users:dagnall53:rocclienttool [2018/11/12 08:56] – external edit 127.0.0.1users:dagnall53:rocclienttool [2019/10/08 21:48] – dagnall53
Line 2: Line 2:
  \\   \\ 
 **ESP8266 Rocnet Nodes**  **ESP8266 Rocnet Nodes** 
-  * [[:users:Dagnall53:Description|ESPRocNetSoundDescription]] +  * [[:users:Dagnall53:Description|See WiRocS module descriptions]] 
   * [[https://github.com/dagnall53/ESPMQTTRocnetSound|ESP8266 Code]]   * [[https://github.com/dagnall53/ESPMQTTRocnetSound|ESP8266 Code]]
   * [[:users:Dagnall53:Node_Setup|Node_Setup]]    * [[:users:Dagnall53:Node_Setup|Node_Setup]] 
Line 22: Line 22:
 Once the tool has a list of switches on the layout (it can take up to about 100), it displays these as a list\\ Then, using up and down buttons (or a rotary selector), the desired switch is selected.\\ Once the tool has a list of switches on the layout (it can take up to about 100), it displays these as a list\\ Then, using up and down buttons (or a rotary selector), the desired switch is selected.\\
 Clicking "right" on the 5 way selector built into the wemos demo board, the tool interrogates the Rocnet Pi03 address selected and obtains the current Left and Right position settings.\\ Clicking "right" on the 5 way selector built into the wemos demo board, the tool interrogates the Rocnet Pi03 address selected and obtains the current Left and Right position settings.\\
-The tool initially displays the Left setting. If you press up or down (5way switch on the rotary switch if fitted), then the "Left" setting will be altered, and sent to the Rocnet Node,so you should see the servo move slightly. You can then move the servo to the exact position needed. Pressing "Right" switches to the Right" setting. Pressing Right again scrolls back to the turnout selector, so you can repeat the process. +The tool initially displays the Left setting. If you press up or down (5way switch or the rotary switch if fitted), then the "Left" setting will be altered, and sent to the Rocnet Node,so you should see the servo move slightly. You can then move the servo to the exact position needed. Pressing "Right" switches to the Right" setting. Pressing Right again scrolls back to the turnout selector, so you can repeat the process. 
 There is a video of how it works here: [[https://www.youtube.com/watch?v=kwU2oWAyCBs&feature=youtu.be]] There is a video of how it works here: [[https://www.youtube.com/watch?v=kwU2oWAyCBs&feature=youtu.be]]