wio:wiopi-01-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
wio:wiopi-01-en [2021/01/15 11:04] – rjversluis | wio:wiopi-01-en [2023/08/17 07:42] (current) – rjversluis | ||
---|---|---|---|
Line 1: | Line 1: | ||
======WIOpi-01====== | ======WIOpi-01====== | ||
[[: | [[: | ||
- | * [[: | + | * [[: |
* **[[: | * **[[: | ||
* [[: | * [[: | ||
\\ | \\ | ||
- | | Current WIOpi software and WIOpi-01 are not completely pin compatible. | | + | {{ :wio:wiopi-01-pcb.jpg?300}} |
\\ | \\ | ||
+ | |||
+ | =====Zero header side===== | ||
+ | The WIOpi-01 PCB expects the Zero header at the bottom side:\\ | ||
+ | {{: | ||
+ | Buy a Zero type **W**, and __not__ type WH. The header of type WH is on top.\\ | ||
+ | \\ | ||
+ | If a Zero with the header on top is already available, the Zero connector on the WIOpi-01 can also be mounted at the bottom side of the PCB.\\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====Mobile Drive===== | ||
+ | Important wiopi.ini settings: | ||
+ | * mobiletype -> 1 for H-Bridge | ||
+ | * batterytype | ||
+ | |||
+ | See: [[https:// | ||
+ | |||
+ | \\ | ||
+ | |||
+ | |||
+ | |||
=====Pixel===== | =====Pixel===== | ||
The WS2801 LED strips connection: | The WS2801 LED strips connection: | ||
Line 32: | Line 53: | ||
\\ | \\ | ||
=====Files===== | =====Files===== | ||
- | * [[https:// | + | * [[https:// |
- | * [[https:// | + |
wio/wiopi-01-en.1610705060.txt.gz · Last modified: 2021/01/15 11:04 by rjversluis