xpressnet-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
xpressnet-en [2019/12/01 09:49] – rjversluis | xpressnet-en [2023/06/16 12:18] (current) – [LZV200] rjversluis | ||
---|---|---|---|
Line 8: | Line 8: | ||
===== Setup ===== | ===== Setup ===== | ||
- | Library | + | | Rocrail library |
{{: | {{: | ||
Line 21: | Line 21: | ||
The LI-USB manual says to use no hardware handshake, but if buffer overflows are encountered or unexpected communication errors it is recommended to set this to CTS.\\ | The LI-USB manual says to use no hardware handshake, but if buffer overflows are encountered or unexpected communication errors it is recommended to set this to CTS.\\ | ||
Uncheck the handshake if the no communication is possible.\\ | Uncheck the handshake if the no communication is possible.\\ | ||
- | ====LZV200 & CTS ==== | + | |
- | The LZV200 does not support CTS handshake, and must be turned off.\\ | + | |
\\ | \\ | ||
Line 35: | Line 34: | ||
| CtTran | CtTran | cttran | Same implementation as ' | | CtTran | CtTran | cttran | Same implementation as ' | ||
| [[http:// | | [[http:// | ||
+ | | S88XPressNetLi-USB | LI101F | default | Baudrate: 9600. RoSoft | OK | | ||
¹) Depends on the device driver and operating system; Runs well with activated handshake under Mac OS X Lion.\\ | ¹) Depends on the device driver and operating system; Runs well with activated handshake under Mac OS X Lion.\\ | ||
²) Replaced by Lenz interface 23151.\\ | ²) Replaced by Lenz interface 23151.\\ | ||
+ | \\ | ||
+ | |||
+ | |||
+ | \\ | ||
+ | =====LZV200===== | ||
+ | Type: **Li-USB**\\ | ||
+ | ====CTS==== | ||
+ | The LZV200 does not support CTS handshake, and must be turned off.\\ | ||
+ | ====Firmware==== | ||
+ | The firmware of the LZV200 must be at least 3.8.\\ | ||
\\ | \\ | ||
xpressnet-en.1575190171.txt.gz · Last modified: 2019/12/01 09:49 by rjversluis