Table of Contents

OpenDecoder

OpenDecoder 1

opendcc.de_elektronik_opendecoder_platine_bestueckt.jpg

Mode 3

Main signal

  1. Interface
    • Protocol: NMRA-DCC
    • Address Main Signal: 1, 5, 9 or 13 and so on. (Flat addressing: 8 addresses per decoder)
    • Port: 0, Flat addressing
    • Control: Linear
    • Type: Accessory
    • Option: As switch
  2. Details
    • Aspects: 3 or 4
    • Signal Type: Lights
    • Signification: Main
    • Aspect number: green=2, red=1, yellow=0, white=3


Important

The aspect numbers will map the output/aspect of the decoder; Change according your needs.

  • In case the signal symbol shows “red” and the signal LED is showing “green”, just swap 2 and 1. Keep the aspect numbers in the range of 0 - 3; Higher values will address the next decoder.

Distant signal

Use the same settings as for the main signal except for:

  1. Interface
    • Address: 3, 7, 11, or 15 and so on.
  2. Details
    • Aspects: 3 or 2
    • Signification: Distant

Personal Tools