Locomotives: Calibrate

Calibrate Tab

CV 5, 6

The following values are used in case an MVTrack calibrating command:

Max. km/h

The max. km/h to use for calibrating.
If zero the V_Max value on the interface tab is used.

CV 5

The maximum decoder speed CV 5 value range; Check the decoder manual for the correct values.

CV 6

The percentage, default 30%, of the calculated CV 5 value to save in CV 6. (CV 6 is the mid decoder speed. Check the decoder manual if CV 6 is supported.)
With the checkbox on the right the POM programming of CV 6 can be enabled or disabled.

Common Buttons

Personal Tools