arduino:wio-setup-en
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| arduino:wio-setup-en [2025/05/27 07:16] – rjversluis | arduino:wio-setup-en [2025/10/29 07:51] (current) – rjversluis | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| [[: | [[: | ||
| **[[: | **[[: | ||
| - | * **[[: | + | * **[[: |
| Line 105: | Line 105: | ||
| Count of 100ms for setting the output pulse length.\\ | Count of 100ms for setting the output pulse length.\\ | ||
| Also used for dual coil switch motors.\\ | Also used for dual coil switch motors.\\ | ||
| + | |||
| + | ====Block timer==== | ||
| + | The time between the last upper flank and reporting the sensor off.\\ | ||
| + | Default 2 seconds. (2000ms)\\ | ||
| ====Port==== | ====Port==== | ||
| Line 354: | Line 358: | ||
| \\ | \\ | ||
| - | =====OTA from Scratch===== | + | ====OTA from Scratch==== |
| To avoid bothering with the needed libraries for the WIO Sketch this {{: | To avoid bothering with the needed libraries for the WIO Sketch this {{: | ||
| ( The Sketch can also be downloaded from https:// | ( The Sketch can also be downloaded from https:// | ||
| Line 372: | Line 376: | ||
| | {{: | | {{: | ||
| | Discovery | | Discovery | ||
| + | |||
| + | |||
| + | \\ | ||
| + | < | ||
| + | =====Files===== | ||
| + | File management for WIO CAN.\\ | ||
| Line 418: | Line 428: | ||
| Delete the '' | Delete the '' | ||
| - | ====Location==== | + | ====File location==== |
| {{ : | {{ : | ||
| The User CVs are saved in the usrcv.bin file.\\ | The User CVs are saved in the usrcv.bin file.\\ | ||
| Line 440: | Line 450: | ||
| | 12 | Stepper_ISR_Accel | | 50 | | | | Start/end delay (number of steps for accelerate and decelerate) -> range | | | 12 | Stepper_ISR_Accel | | 50 | | | | Start/end delay (number of steps for accelerate and decelerate) -> range | | ||
| | 13 | Stepper_ISR_Accel_Step | | 15 | | | | Number of ticks before add/ | | 13 | Stepper_ISR_Accel_Step | | 15 | | | | Number of ticks before add/ | ||
| + | | 14 | User_altitude | | 104 | | | | https:// | ||
arduino/wio-setup-en.1748323001.txt.gz · Last modified: 2025/05/27 07:16 by rjversluis