Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== CAN-GC8 Display Driver ======
+[[english|{{  rocrail-logo-35.png}}]]
+[[:english|Content]] -> [[:hardware-en|Hardware]] -> [[:hardware-en#gca-cbus|CANBUS]]
+  * [[:cbus:overview-en|CAN-GC Overview]]
+  * [[:can-gca1-en|CAN-GC1]] | [[:can-gca1e-en|CAN-GC1e]] | [[:can-gcln-en|CAN-GCLN]] | [[:can-gca2-en|CAN-GC2]] | [[:can-gc3-en|CAN-GC3]] | [[:can-gc4-en|CAN-GC4]] | [[:can-gca5-en|CAN-GC5]] | [[:can-gc6-en|CAN-GC6]] |  [[:can-gc7-en|CAN-GC7]] | **[[:can-gc8-en|CAN-GC8]]**
+    * [[:cangc8-firmware-en|Firmware]]
+{{ :cbus:display-goes.jpg?300}}
+ \\
+^By Rob Versluis  & Peter Giling^
+ \\
+ \\
+{{:cbus:cangc8-gc2-2.jpg?300}}{{:cbus:can-gc8-demo.jpg?300}}
+ \\
+ \\
+The firmware development of the CAN-GC8 uses the same board as the [[:can-gca2-en|CAN-GC2]], and is for controlling two displays compatible with "[[http://www.reichelt.de/?;ARTICLE=77834|DOG Series]]".\\
+ \\
+===== Features =====
+  * Driver for two displays.
+  * Linefeed controlled by pipe character.
+  * Adjustable contrast.
+  * First line double high option.
+ \\
+=====Display Connection=====
+Display1 = J4\\
+Display2 = J3\\
+^ SPI ^ J3 ^ J4 ^ Remark ^
+| +5V | 1 | 1 | |
+| GND | 2 | 2 | Ground |
+| SI | 3 | 3 | Serial data in |
+| CLK | 4 | 4 | Clock |
+| CSB | 5 | 5 | Chip select |
+| RS | 6 | 6 | Command or Data |
+ \\
+<html><a name="setup"/></html>
+===== Setup =====
+{{:cbus:cangc8-query.png}}\\
+The CAN-GC8 shows up in the query.\\
+{{:cbus:cangc8-setup-en.png}}\\
+====Event number====
+Short event number; Long events are not supported.\\
+====Contrast====
+Display contrast 0...15.\\
+====First line double high====
+Show the first line double high if the used display does support this option.\\
+====Show clock====
+Show the clock on the first line and date/temp. on the bottom line.\\